Flat Roof Repair - How to Repair Your Flat Roof

Flat Roof Repair - Unless expensive materials have been used, the average life of a felted flat roof is about 10 to 15 years. If a felted flat roof fails, it is not worth trying to repair it and you should re-cover it. However, there are things you can do to repair minor faults and to extend its life before it needs to be replaced. Failure to act result in water leaking through to the timber below and causing rot.

You will need bituminous mastic (caulking) to repair a crack or blister in a felted flat roof. Although quite messy, the job is straightforward. First remove any loose chippings from around the damaged area with a brush. Using a hot-air gun, soften the felt first if necessary, and brush or scrape away dirt, moss or any other debris. With a crack or split in the roofing felt, pull back the edges; with a blister, make a cross-shaped pattern of cuts in the centre of the blister and peel back the four sections. If any seams are lifting, clean the area below them.

When the underlying surface has dried out - use a hot-air gun to to speed this up if necessary - apply mastic to the exposed area and press down the edges of the cracks, blister or lifted seams, using something like a wallpaper seam roller. If a crack cannot be closed up, use polyester reinforcing tape or flashing tape to strengthen the repair.

Some emergency roof repair compounds can be used to seal a leaking roof been if it is wet or under water. Instant repair aerosols can be used on damp roofs (and also on leaking flashing or guttering); check the manufacturer's instructions. If a felted flat roof has several cracks and blisters, or is generally in bad condition, it is possible to waterproof it with either a bituminous emulsion or a longer-lasting elastometric liquid rubber.

When carrying out a decent and efficient Flat Roof Repair, the whole roof should be swept clean before treating the surface wide with fungicide to kill any mould. Carry out any local repairs, then cover the surface with the emulsion or liquid rubber, tipping it out from the container and spreading it with a soft brush it broom. Sponge away any splashes with solvent.

Some bituminous emulsions need a priming coat before the main coat; all liquid rubber compounds are one-coat treatments and they last longer because they remain flexible. When emulsion or liquid rubber coating has dried, reapply stone chippings. Use new chippings if the old ones are dirty or have lost their shine - the purpose of the stone clippings on flat roofs is to keep them cool by reflecting sunlight.

The junction between a flat roof and the house wall is particularly prone to damage, allowing water to seep through. The correct way to seal this joint is with lead flashing, inserted into one of the mortar courses of the wall. If a mortar fillet has been used to seal the junction, or if lead flashing has split, the simplest way to effect a repair is by using a self-adhesive bituminous flashing tape. Choose the appropriate type of tape to the task in hand when carrying out your flat roof repair.

Clean the surfaces that are to be covered and apply any necessary primer before removing the backing paper and pressing down the flashing tape, first with your fingers, then a seam roller. Wear heavy gloves when doing this as it can be messy.

The tape can be cut with scissors if required. Make good the mortar joints where any lead flashing meets the house wall, using fresh mortar.

Be sure to check out how to unblock Blocked Drains which also shows how to do that yourself.